Square, rectangular, and round ERW tube that goes straight into your product — telescoping fits, flash-controlled IDs, dedimpled ends, and formable grades, from 18 ga to 1/4″ wall, mill-direct from Mansfield, Ohio.
OEM tube has a job to do after it leaves the mill — it gets punched, formed, welded, telescoped, or coated. Our fabrication customers spec formability grades, fit-up tolerances, and end conditions, and we hold them run after run: support hardware, carrier racks, wall jacks, dock ladders, telescoping supports, and engineered building components.
Specs: ASTM A513 mechanical for parts, A500 for structural members (to 1/4″ wall, 2″×6″), and A1076 UV-coated precoated rounds for certified building components. Not sure which? Start with the A500 vs A513 comparison.
Square, rectangular, and round ERW tube from 18 ga up through 1/4″ wall, in hot rolled, HRPO, and galvanized — to ASTM A513 for mechanical parts, A500 for structural members, and A1076 UV-coated precoated tube for building components like truss webbing. Typical end uses on our spec sheets: support hardware, wall jacks, carrier racks, dock ladders, and telescoping assemblies.
Yes — we run tube specified to telescope into or over a mating tube, with ID/OD controlled to the fit. Tell us both members of the assembly and we'll tool to the clearance.
Flash-controlled ID down to .010″–.020″ per customer spec, plus dedimpled ends — both are standard requests from our OEM accounts, held to the spec sheet on every run.
Yes — chemistry-controlled grades for forming operations, higher-strength grades on request, and certified A1076 structural grades (e.g., Grade 42/65 rounds) for engineered building components. Certs ship with the material.
Spec, sizes, fit-up, end condition, and annual volume — we'll quote it the way your line needs it.
Request a Quote
